You have a programable interface with software. Therefore the drivers seem to be OK and the same as the genuine drivers.ĮDIT: I've attached pictures of the board. I also tried the 32-bit version of the genuine software using the drivers supplied with the cable and get the same problem. Therefore the problem seems to be the cable. This was the same problem I had when I tested the cable / software on my friend's 32-bit XP laptop using the supplied software. 'Interface not found!' when the cable is connected to the car and 'Interface found' with Status 'Not plugged into car!' when testing without plugging the cable into the car. I then downloaded the genuine software and tried it again but get the same problems. Windows gives me an error and the software won't start.

I checked again with the supplied software but can not get it to install on my 64 bit system.

I did notice a few missing parts (an IC and some resistor/capacitors) but nothing else seemed wrong. I also tested the 5v regulator and it works fine. Latest Full 14.10 12.12.3 VCDS VAGCOM Software. (08-01-2014, 00:37 AM)milo Wrote: Update - So I opened the cable and checked. LATEST VAG COM VCDS 12.12.3 HEX CAN USB DIAGNOSTIC CABLE OBD 2 AUDI VW SEAT SKODA. With other words if you want to make a clone to works with this dump you need to bypass the FTDI IDĮxample: if you have two genuine new style VCDS tools and you want to change the Atmega from one to the other one and vice-versa, then both tools will not worksĬonclusion you'll get it by yourself about the softwear that your tools works In this case you cannot use the original softwear not moded ( craked ) with no matter what kind of clone do you use ( BL/BM/RL) just because as I said the Atmega dump it is 'marriaged' with the FTDI ID 12 diagnostic cable works with Windows 2000, XP, Vista, and both 32-bit and 64-bit. VCDS 15.7. If you have a dump from new style of genuine tool then this dump it is marriaged with the FTDI RQ ID. Now if you have a dump from number one then the clones (with BL/BM ) can works directlly with the original softwear from ross-techīut if you use this dump with a RL tool then you need a loader to use your clone or to mode (use meds) the softwears Guys if you don't know allready about how the genuine tools are please let me tell you

Vag 12.12 cable